Click HERE to find and print your tutorial sheet.
Radiant Sunflower Birthday
All
images © 1990-2026 Stampin’ Up!®
Supplies:
·
Stamp Sets: Radiant Sunflower Bundle (168359); Phrases &
Frames stamp set (167581)
·
Cardstock and Paper: Golden Glow (167685); Early
Espresso (119686); Very Vanilla (166784); Cajun Craze (119684); Old Olive (100702);
Sunflower Fields Designer Series Paper (168351); Radiant Foils Specialty
Designer Series Paper (168362)
·
Stamp Pads: Early Espresso (147114);
Golden Glow (167676)
·
Tools: Stampin’ Cut & Emboss
Machine (149653); Radiant Sunflowers Dies (168352); Scalloped Christmas Cheer
Dies (168544); Softly Woven 3D Embossing Folder (168466); Small Blending
Brushes (160518); Detail Scissors (170902)
·
Miscellaneous: Golden Glow Bordered Ribbon
(167548); Golden Glow Shimmer Brush (168425); White Gel Pens (166642); Stampin’
Dimensionals (104430); Multipurpose Liquid Glue (110755); Mini Glue Dots
(103683); Tear & Tape Adhesive (154031)
Measurements:
· Golden Glow Card Stock (CS): 5 ½” x 8 ½” scored @ 4 ¼” on long side
·
Early Espresso CS: 4” x 5 ¼
·
Sunflower Fields Designer Series Paper (DSP): 3 7/8” x 5 1/8”
·
Very Vanilla CS: 3 ¾” x 5”, 1 ½” x 2 5/8”, 3” x ½” strip for
sentiment
Instructions:
1. Burnish Golden Glow card base along score line.
2. Use the second smallest
Scalloped Christmas Cheer Die to cut a frame from the center of the Early
Espresso card stock (this cut out will be hidden by the DSP in step 4).
3. Run the sunflower print DSP
through the Softly Woven 3D Embossing Folder and roll over/distress the top
right and bottom left corners. Adhere to
the Early Espresso 4 x 5 ¼” CS layer.
4. Cut 6” of the ribbon and use
Tear N Tape to adhere to the back of the above piece. Tie a knot on the left side of the ribbon, as
pictured, and trim as desired. Adhere to card base.
5. Using
a Blending Brush, lightly apply Golden Glow ink to center of Very Vanilla CS and
adhere to center of Early Espresso Scalloped Frame.
6. Use Radiant Sunflowers Dies
to cut the flower (Cajun Craze), flower center (early espresso), leaves (Old
Olive), and vase (Radiant Foils). Use
Glue dots to assemble as shown.
7. Use the Golden Glow Shimmer
Brush to add sparkle to the accent lines on the sunflower and leaves die cuts.
8. Use Stampin’ Dimensionals to
adhere the frame with vase to the center of card front over the ribbon.
9. Stamp the sentiment on the
strip of Very Vanilla CS using Early Espresso ink. Use the Detail Scissors to
angle-cut each end.
10. If desired, use the blending
brush to add Golden Glow ink to the edges of the sentiment strip.
11. Adhere
the sentiment with liquid glue or glue dot over the vase and with a Stampin’
Dimensional on the right side so it is the same level as the part over the
vase.
12. Adhere
the 3 ¾” x 5” Very Vanilla CS panel to the inside of card after stamping and
decorating as desired.
No comments:
Post a Comment